Panel Cookies
Mist Humidifier - Schematic
05/03/2022 | Views: 7769 | Robotics | by: ELECTRONOOBS      

The schematic for this project is this one. The Arduino will control when the fan and the generator are powered on using a timer. To control that we have 3 buttons but we might only use 2 of them. Before we make any connection we first have to water seal the container part using resin and let it dry because it will take a few hours. That part must be weater seal and not leak at all since it will be on top of the electronics.

Homemade Arduino emist humidifier generator 3D printed tutorial

Last tutorials

Measure AC RMS with Arduino
ESP32 and Alexa Light control + PCB
Dev Board - OLED control
Homemade EGS002 Full SINE Inverter
433MHz Radio Light Switch Control - PCB



PCBWAY PCB service

Curso Arduino Online nivel bajo