Temperature Controller - 3D Case
20/03/2021 | Views: 2363 | Arduino | by: ELECTRONOOBS      


Below you have all the 3D parts needed for this project. No need for supports. I've used PLA filament at 200 degrees with 3 perimeters, 20% infill and 0.2mm layer height. My printer has a 0.4mm nozzle. Then you need some insert treads for the screws and that's it. The parts are already oriented so you don't need to rotate them.


Arduino homemade temperature controller 3D case










Last tutorials

Half Bridge ESC for brushless motor with common point
Latch Circuit - Completely turn ON/OFF the microcontrolle
Latch Circuit - On and Off
Smart Glasses Arduino Multimeter
Gauges on a Nextion Display

ADVERTISERS



>

ADVERTISERS

PCBWAY PCB service

PCBWAY PCB service





Arduino curso en español desde cero