STM32 Radio COntroller - 3D Case
20/06/2021 | Views: 5760 | Arduino | by: ELECTRONOOBS      


Print the case with PLA and 0.2mm layer height, 2 perimeters and 20% infill and no supports! Ok, we need to paint the case a little bit since white doesn’t look that good. So, we sandpaper it a bit. I first applied a coat of primer. After a few hours I’ve sandpapered the case again and then I’ve used some spray paint and paint it black. If needed we can apply more than one coat of paint. I've also painted the buttons with a gold color.


3D Printed Radio Controller Case STL files download










Last tutorials

Shocking Game - Lie detector | 3D printed
Homemade Balanced BMS circuit - Current Limi
Panelized PCB, solder components at once with SMD stencil
Arduino101 - All About ADCs | REGISTERs
Homemade Reflow Hot plate for SMD components

ADVERTISERS



>

ADVERTISERS

PCBWAY PCB service

PCBWAY PCB service





Curso Arduino Online nivel bajo