Panel Cookies
Two Hand Multimeter - Schematic
13/08/2022 | Views: 11332 | Arduino | by: ELECTRONOOBS      


The scheamtic is complex but I've tried to separate it into individual parts for voltage measurement, resistance, current and so on. You could solder each part one by one and test them out for degug. Soldering 0402 components is not that difficult. Aslo, if you don't use the BT module, you don't have to solder it neighter the 3.3V regulator. Follow the values below.












Last tutorials

Tesla Coil on PCB
10A Bharger/Protection Module
TMC silent driver comparison A4988 stepper driver
ESP32 and Alexa Light control + PCB
Dev Board - OLED control

ADVERTISERS



>

ADVERTISERS



PCBWAY PCB service





Curso Arduino Online nivel Intermedio