Panel Cookies
433MHz Relay Control - Receiver
17/10/2020 | Views: 17794 | Arduino | by: ELECTRONOOBS      


Below you have the scheamtic for the receiver. Since the solid state relay module on the PCB is too big, I had to take it out from the PCB and solder the circuit on a small PCB so it could fit inside the case. You have the circuit below with a NPN transistor and a few resistors. Connect 220VAC to the converter and the 12VDC output connect it to the RAW pin of the Arduino Pro Mini. Connect pin D2 to the relay circuit. Connect D11 to the radio receiver. Share GND with the entire ciruit.



Homemade 433MHz radio receiver relay










Last tutorials

Plasma Toroid Generator, whaaat?
DIY High Quality Microphone JLI2555 capsule
DIY Laser Power Meter for 10$ (PCB & code)
Fully Portable Battery Soldering Iron
Turbo Air Blower with Brushless motor + 3D printed case

ADVERTISERS



Affiliate Disclosure

ADVERTISERS








Curso Arduino Online nivel Intermedio