Panel Cookies
Filament from Bottle - 3D Files
29/07/2022 | Views: 65921 | Arduino | by: ELECTRONOOBS      


We have these 3D printed parts below. Two big gears and a cylinder in between, the spool for the bottle plastic strip. All these parts were printed with PLA filament, 0.2mm layer height, 2 perimeters, 20% infill and 0.4mm nozzle. To increase torque, I’ve made another small gear and this gear will be rotating with another smaller gear connected to a stepper motor. I’ve made two support sides to keep the gears in place.












Last tutorials

Tesla Coil on PCB
433MHz Radio Light Switch Control - PCB
Extract code from an Arduino
Arduino Breath Alcohol Meter
Dual Rail Supply

ADVERTISERS



>

ADVERTISERS



PCBWAY PCB service





Curso Arduino Online nivel bajo