MPPT Controller
25/12/2020 | Views: 18466 | Arduino | by: ELECTRONOOBS      


Below you have all the parts needed for this prototype. Remember that in the video I've used a BC547 NPN at the gate of the MOSFET but is better to use a PNP and have always a pulldown at the gate of the MOSFET for safety. The current sensor is the model of 5A but you could use any oter but remember to change the multiplier in the code. As for the relay, you could buy directly a module and don't use the small NPN to activate it. For the power lines I recommend you to buy thick copper wire. Get the small buck converter and fix it to 5V and glue the potentiometer.


Arduino homemade MPPT controller










Last tutorials

Shocking Game - Lie detector | 3D printed
Homemade Balanced BMS circuit - Current Limi
Panelized PCB, solder components at once with SMD stencil
Arduino101 - All About ADCs | REGISTERs
Homemade Reflow Hot plate for SMD components

ADVERTISERS



>

ADVERTISERS

PCBWAY PCB service

PCBWAY PCB service





Curso Arduino Online nivel bajo